Filter
Top Products
placed into it. To estimate the possible
product load weight it is generally conceded
that a safe figure is 35 pounds for each net
cubic foot storage space. For example, a 47
cubic foot cabinet could hold approximately
1645 pounds of product (47 x 35 = 1645).
2. Ventilation - The air cooled, self-contained
merchandiser refrigerator requires a sufficient
amount of cool, clean air. Avoid placing the
refrigerator near heat generating equipment
such as ovens, ranges, heaters, fryers,
steam kettles, etc., and out of direct
sunlight. Avoid locating the self-contained
refrigerator in an unheated room, or where
the room temperature may be below 55°F.
E. Installation of Optional Legs or Casters
Merchandisers are shipped with leveler bolts
that can be used to level the cabinet. However,
legs and casters can be supplied that are of the
1/2" single stud mount type and requires no
tools for installation. Simply remove the leveler
bolts and then screw the casters or legs into the
threaded holes located on the case bottom. To
install low-profile rollers, remove carriage bolts
from caster mounting plates and insert stem
into bolt hole and tighten nut. Make sure that
torque of caster bracket is inserted into 1/2”
hole. This will prevent caster from turning.
Tilt the cabinet in one direction approximately
eight inches and block it securely to keep it from
falling. Use several pieces of 2 x 4 lumber or
other suitable material. Screws the two left or
right legs in snug. Repeat this procedure to
install the other legs with the case bottom.
WARNING
Never, Under Any Circumstances,
Lay Your New Merchandiser Refrigerator
Down On Either It’s Back, Front or Sides.
F. Leveling
Cabinet must be leveled when installed. This is
accomplished by rotating the leveler bolt.
Failure to level your cabinet may result in
doors not sealing, closing properly or
condensate water not draining properly.
G. Initial Cabinet Set-Up
Units are shipped with shelves. These items
are secured to the rear of the cabinet directly on
the wood skid.
1. Cleaning Cabinet
CAUTION:
DO NOT Use Abrasive Cleaning Solvents.
Never scour any part of your new cabinet.
Scouring powders or chemicals may cause
damage by scratching or dulling the surface
finish. Prior to placing your new merchandiser
refrigerator and all shelves into operation, it is
advisable that the interior be washed
thoroughly with a mild detergent and water
solution. Rinse with clear water and a
sanitizing solution. Allow cabinet to air dry.
For additional cleaning information, refer to the
maintenance section of this service manual.
2. Installing Shelves
All merchandiser models include an interior
which supports the adjustable and gravity
organizing shelving.
Refer to pages 9 to 12 for detailed and
illustrated shelf installation instructions for both
standard shelving and beverage shelf kits.
H. Electric Supply
The wiring should be done by a qualified
electrician in accordance with local electrical
codes. A separate ground wire must be
supplied for all installations. A properly wired
merchandiser refrigerator will assure proper
operation. Please consult the "Data" plate
attached to the compressor to assure the
electrical requirements are correct. Supply
voltage requirements are on the cabinet serial
plate. It is recommended that a direct, properly
fused line of the proper size wire be installed
7
Section 2- Installation
Section 2- Installation