Filter
Top Products
Advanced Operations
86 ViewCast
Starting an encoder group
To start an encoder group, click the Start link to the right in the Start column of the group you want to
start. The encoder group will start in a few seconds. The system displays any errors on the Starting
window while the group starts.
Note: With each encoder started, more system resources (CPU cycles) are consumed. It is recommended
that the total CPU threshold not exceed an average of 70 %. Refer to the Checking CPU usage
section in Basic Operations.
Stopping an encoder group
To stop an encoder group, click the Stop link to the right in the Stop column of the group you want to
stop. The encoder group will stop in a few seconds. The system displays any errors on the Stopping
window while the group stops.