Filter
Top Products
PILOT ASSEMBLY REMOVAL
Disconnect the electrical power and follow lockout / tagout procedures
Shut off gas supply
-
15 -
1. Remove control panel and heat shield
2. Reaching underneath the front of the
unit, remove the pilot tube fitting and
disengage the pilot tube from the pilot.
3. Pull the flame switch probe straight
down and out from the snap in retainer.
4. Reaching underneath the front of the
unit, remove the pilot bracket retaining
screw(#2 Phillips) and remove the
entire assembly out through the pilot
access cutout and out from under the
unit.
5. Disconnect the electrode wire from the
from the bottom terminal of the spark
igniter module.
BRACKET RETAINING SCREW
FLAME SWITCH PROBE
PILOT ASSEMBLY
SNAP IN RETAINER
PILOT TUBE FITTING
PILOT ACCESS CUTOUT
6. Remove the pilot from the bracket.
7. Reverse procedure to install
8. Verify gas pressure and check for
proper operation
All gas joints disturbed during servicing must be checked for leaks.
Check with a soap and water solution. Do not use an open flame.
HELPFUL HINT – If the unit is attached to a flexible gas line, you can extend the bullet feet out to their
fullest extension to raise the griddle and allow yourself more clearance while reaching under the unit.
Remember to relevel the unit if you chose to do this.
BURNER
The 900RE and AGE utilize “U”-shaped burner with a single center inlet for every 12 inches of
griddle width. Each burner is rated for 30,000 BTU/hr.