Filter
Top Products
HEAT SHIELD
Disconnect the
electrical power and follow
lockout / tagout procedures
The heat shield protects the electrical
components and should only be
temporarily removed for easier
replacement of some the control
components.
1. Remove the control panel.
2. Remove screws along the top edge
that secure the heat shield.
3. The shield clamps on the front of the
chassis and can be removed by
grasping the top of the shield and
pulling forward.
BACK PANEL
It should only be necessary to remove the back panel when changing a burner or to remove
excessive grease build up from the flue area.
1. Disconnect gas supply at griddle.
2. Remove all screws from rear of griddle securing the back panel.
3. Reverse the procedure to install.
THERMOSTAT
Thermostat
Capillary wire insulation
Capillary
bulb
The thermostat is a snap action, single pole – single throw type. The thermostat supplies power to
the main burner solenoid valves when turned on or until the temperature set point is reached.
-
7 -