Filter
Top Products
— 8 —
2. Oven Door Turnbuckle
NOTE: For the 24L and 48L units, refer to procedure outlined under 2A.
If the oven door is not closing properly, the door turnbuckle may require adjustment. To adjust the turnbuckle, flip down
the lower front kick panel. The turnbuckle is connected between the right- and left-hand door springs (Fig. 1). With your
hand, rotate the cast center piece of the turnbuckle two rotations at a time, then check the door tension. Repeat this
procedure until the door works as desired. After adjustment has been made, tighten the locknuts.
SERVICING SIMPLE CHECKS AND ADJUSTMENTS (Cont.)
Fig. 1
2A. 24L and 48L Oven Door J-Bolt Assembly
If the oven door is not closing properly, the door J-bolt assembly may require adjustment. To adjust the J-bolt assembly,
flip down the lower front kick panel. The J-bolt assembly is connected to the right-hand bell crank arm (Fig. 2). The
adjustment is made by the two
1
/4-20 locknuts. Turn each nut in a clockwise direction to increase tension on the door; turn
each nut in a counterclockwise direction to decrease the tension. Repeat this procedure until door works as desired. After
adjustment has been made, tighten the locknuts.
Fig. 2