Filter
Top Products
V SERIES HOLDING, TRANSPORT & PROOFING CABINET F-41190 (09-10)
3
GENERAL
INTRODUCTION
Vulcan-Hart Holding & Transport and
Proofing Cabinets are produced with
quality workmanship and material.
Proper installation, usage, and
maintenance of your cabinet will result
in many years of satisfactory
performance.
It is suggested that you thoroughly read
this entire manual and carefully follow all
of the instructions provided.
INSTALLATION
Before installing, verify that the electrical
service agrees with the specifications on
the rating plate located on the lower
back corner of the cabinet. (Fig. 4) If
the supply and equipment requirements
do not agree, do not proceed with
unpacking and installation. Contact
your Vulcan-Hart Customer Service
Department immediately.
UNPACKING:
The Cabinet was inspected before
leaving the factory. The transportation
company assumes full responsibility for
safe delivery upon acceptance of the
shipment. Immediately after unpacking,
check for possible shipping damage to
the cabinet.
If the cabinet is found to be damaged,
save the packaging material and
contact the carrier within 15 days of
delivery.
Carefully unpack and place in a work
accessible area as near the installation
position as possible.
1. Open the door and carefully
remove any packaging materials.
Remove 20 Tray Slides and 2
Water Pans. (10”x12”x2½”)
2. Peel off all vinyl protection film.
3. Install desired number of Tray
Slides. Make sure the hook on
the end of the tray slide is up.
(Fig. 1)
(Fig. 1)
4. Insert one (1) Water Pan in
opening at the bottom of the
cabinet and insert one (1) Water
Pan through slides underneath
the cabinet. (Fig. 2)
WATER PAN
WATER PAN (Fig. 2)