Waring WMN250 Blender User Manual


 
6
7
4. CAUTION: DO NOT use carbonated liquids in the blender
jar or any blending container.Using carbonated liquids in
the blender jar or any blending container may result in injury.
5. Put ingredients into container, then put on cover. Always
add liquid ingredients rst, unless otherwise specied in
recipe. Always hold container with one hand while blending.
6. CAUTION: To avoid damage to your blender, do not run the
blender if the blades become blocked or jammed during
use. Turn the blender off immediately, remove the container
from the blender base and dislodge the material that is
blocking or jamming the blade.
HOW TO ASSEMBLE CONTAINERS
WITH REMOVABLE BLADES
1. Before starting, make sure that the
blender cord is unplugged and that
the switch is in the off position.
2. Refer to Figure 1. The following
points are important to note when
putting together the container
assembly:
3. Container gasket must be between
the blade assembly and the
container.
4. Container collar must not be
misthreaded onto the container.
5. Container collar must be securely
tightened onto the container
before placing food or liquid in the
container.
6. Tighten the container collar by holding the container upside
down and turning the container collar
counterclockwise.
7. Place container assembly on unit base so that it is rmly
seated and not tilted to one side. Never place the container
collar or the blade assembly on the unit base unless the
container has been completely assembled and securely
tightened.
HOW TO DISASSEMBLE & CLEAN
CONTAINERS WITH REMOVABLE BLADES
1. Be sure the switch is in the off position.
2. Remove the container assembly from the unit base and
empty the contents.
3. To disassemble the Waring Pro
®
Blender container
assembly, turn container collar clockwise.
4. The glass container, container collar and blade assembly
are dishwasher safe. The plastic container, lid, measuring
cup lid insert and gasket must be washed by hand. Allow
all parts to air dry, and reassemble for next use.
5. When assembling container after cleaning, be certain all
components are in the proper position.
6. It is particularly important to place the container gasket
between the blade assembly and the container.
7. Wash and rinse container prior to initial use, and
immediately after each use.
HOW TO CLEAN CONTAINERS WITH
NONREMOVABLE BLADES
1. Remove the container from the unit base. Remove the
lid. Add a cup of cleaning solution, made by adding a few
drops of dishwashing detergent to 1 cup of cool water,
to the container. Scrub and ush out the interior of the
container and the lid to dislodge and remove as much
residue as possible. Empty the container.
2. Add more cleaning solution. Put lid on container, place
container on unit base, and run on high speed for
two minutes.
3. Empty the container and repeat as above, using clean rinse
water in place of cleaning solution. Empty, rinse and dry,
prior to storing unit.
4. Wash and rinse container prior to initial use, and
immediately after each use.
Fig.1