Filter
Top Products
OPERATION
Water-Max II™ is used to dispense hot water for food preparation. The
SATELLITE TANK stores five gallons of hot water for immediate use.
INSTALLING OR REMOVING SATELLITE TANK
Drain all water from SATELLITE before attempting to remove from unit.
Press the HEATER SWITCH to
OFF ( O )
Be sure the COVER is properly installed on the SATELLITE
Install or remove SATELLITE on Water-Max II™ shelf by lifting up on
satellite faucet guard.
When installing the tank, make sure that the tank is properly positioned,
that the connector is seated, and that the dispensing nozzle lowered
into position in the satellite cover.
Press the HEATER SWITCH to
ON ( I ). Amber REFILL light will glow
and hot water will begin filling the satellite after 15 - 20 seconds.
Place an appropriate container under the faucet. Being careful not to
overflow the container, pull the faucet handle to dispense hot water.
To Keep Water in Satellite Hot
Leave the heater switch ON. The satellite has an internal heater to
maintain the tank temperature, and will remain ready to dispense hot
water.
Fig. 5 Water-Max™ Operation
WARNING:
BURN HAZARD
Water-Max™ is designed to
operate with a matching 5 gal.
satellite water tank only.
Do not hold anything other
than the matching satellite
under the dispensing nozzle.
Splashing hot water will cause
serious burns.
GENERAL GUIDELINES
NEVER hold or place
anything, other than the proper
satellite, under the dispense
nozzle. Draw water only from
the hot water faucet of the
satellite water tank.
NEVER attempt to remove or
carry a satellite while full of
water.
NEVER attempt to operate
Water-Max II™ without the
cover properly installed on the
satellite
CAUTION:
Hot Surface
Exposed surfaces can be hot
to the touch and may cause
burns.
9
M707 p/n 306692 OpManual WM-TR II
ON
OFF
DISPENSE
NOZZLE
HOT WATER
FAUCET