Filter
Top Products
CONTINUED FROM PAGE 11
After 30 minutes, flush solution from main tank (HEATER SWITCH
OFF):
Insert drain hose into a suitable container. Open drain hose clamp and
drain valve. Allow all solution to drain.
Close drain valve. Reconnect main water supply and allow main tank to
fill (approximately 4 minutes).
After tank is filled, disconnect main water supply and drain tank again.
Flush tank in this manner at least two (2) times.
After flushing tank:
Be sure drain valve and drain hose clamp are closed. Stow drain hose
and reconnect main water supply. After tank is filled (approximately 4
minutes), press HEATER SWITCH to
ON ( I ). After a short delay, main
tank will begin filling. When water reaches proper temperature, satellite
will begin filling.
Procedure is complete
CLEANING INSTRUCTIONS (continued
CAUTION
Burn Hazard
Water in Water-Max II™ is
EXTREMELY HOT! Wear
appropriate heat protective
clothing when draining water
from unit.
IMPORTANT:
Never drain internal tank with
HEATER SWITCH
ON.
Tank heating element will be
damaged if allowed to
operate without water.
For description of features
refer to page 2.
12
M707 p/n 306692 OpManual WM-TR II