Filter
Top Products
Operating Instructions
Continued
The PAUSE HEAT indicator
The “PAUSE HEAT” indicator and current water
temperature will show on the display if the dish-
washer needs additional time to heat water in the
main wash. The water heating will continue until
either the water reaches a temperature between
135°F and 140°F (57°C and 60%) or a preset
time-limit is up. The count down of time remaining
in the cycle delays until “PAUSE HEAT” is
finished. The “PAUSE HEAT” indicator will not
occur if the Pots & Pans Cycle or Hi-Temp Option
is selected (see “HEATING” on page 11).
The CLEAN indicator
“CLEAN” will show on the display at the end of all
cycles except for the Rinse Cycle. If the cycle
included the Heat Dry Option, “CLEAN 8 DRY”
will show at the end of the cycle. The indicator(s)
will stay on until any control pad is pressed.
As an option, you can have the “CLEAN” (or
“CLEAN & DRY”) indicator turn off the first time
you open the door after a cycle is finished:
1. Press and hold the OPTIONS pad until
“CLEAN” shows on the display and starts
blinking.
2. Release the OPTIONS pad. The “CLEAN”
indicator will turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To again have “CLEAN” (or “CLEAN & DRY”) stay
on when the door is opened:
1. Press and hold the OPTIONS pad until
“CLEAN” shows on the display.
2. Release the pad. The “CLEAN” indicator will
turn off.
Other status indicators
“WASHING” shows on the display during the
wash portion of the cycle. The indicator goes off
when the last wash of a cycle is complete.
“RINSING” shows on the display during the rinse
portion of the cycle.