Filter
Top Products
During a cycle, the “HEATING” indicator shows
when the water in the dishwasher is being heated.
In the Pots 8 Pans Cycle or any cycle using the
Hi-Temp Option, the “HEATING” indicator and
water temperature will be displayed several times
if the water needs additional time to be heated.
(See “What happens in each cycle” on pages 12
and 13.)
NOTE: Loads wash best if water temperature is
between 135°F and 140°F (57°C and 60°C). For
best washability, use the Hi-Temp Option (see
page 15). If you select the Hi-Temp Option and the
water does not heat to between 135°F and 140°F
(57°C and 60°C) during the cycle, the display will
show “HI-TEMP LESS THAN 135°F” at the end
of the cycle.
“HEAT DRY’G” or “DRY’G” show on the display
during the drying portion of the cycle.
“DOOR OPEN” shows on the display when the
door is open and any control pad except CANCEL
is pressed when a cycle is not running.
If the door is opened before a cycle begins dry-
ing, “DOOR OPEN” will flash on the display. If the
door is left open longer than 2 hours, “CA” will
replace “DOOR OPEN” and the cycle will have to
be reset.
“RINSED” shows on the display at the end of the
Rinse Cycle. Pressing any control pad will clear
the display.
“SEE DOOR LABEL” and “CA” shows on the dis-
play whenever there has been a power interrup-
tion or failure. (See page 3.)
‘SEE DOOR LABEL” and “EO, El, E2, or E4”
show on the display whenever there has been a
control panel malfunction.
l
Touch the CANCEL pad to clear display.
l
The dishwasher may drain before shutting off.
l
If the display will not clear or continues to show
an “E” code at the end of each cycle, call an
authorized WhirlpoolSM service company. (See
page 26.)
11