Filter
Top Products
Changing a cycle setting
You can change a cycle setting anytime during
any cycle.
1. Press the CANCEL pad. The dishwasher will go
into a 2-minute drain cycle.
2. Be sure the detergent dispensers are filled
properly for the new cycle.
3. Select a new cycle and options.
4. Press the START/FAVORITE pad. The dish-
washer will start the new cycle.
Adding a dish after starting
To be sure the added item is washed and rinsed,
make sure “ADD A DISH” is showing on the
display.
1. Lift up on the door latch to unlatch door and
stop the cycle. Do not open the door until the
spray arms stop spinning.
2. Open the door and add the dish.
3. Close the door. Do not latch it. Wait 30
seconds for air in the dishwasher to warm up.
This helps reduce the amount of moisture that
can come from the vent when restarting the
cycle.
4. Press door firmly to latch it. The dishwasher will
automatically start where it stopped.
Delaying a wash
The delay feature allows you to delay the start
of a cycle from 1 to 9 hours after loading the dish-
washer For example, use the delay feature
to run the dishwasher during off-peak hours of
electrical use.
1. Press the DELAY/PAUSE pad once to display
the last cycle, options and delay selection.
2. Select a new cycle and options, if desired