Filter
Top Products
Surface units and reflector bowls
Removing
1.
Be sure surface units are OFF and COOL.
2.
Lift the edge of the unit opposite the recep-
tacle just enough to clear the reflector
bowl.
3.
Pull the’surface unit straight away from the
receptacle
4.
Lift out the reflector bowl.
Replacing
1.
Be sure surface units are OFF.
2. Line up opening in the reflector bowl with
the surface unit receptacle.
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle.
4. While pushing the surface unit terminal into
the receptacle, lift a little on the edge of
the unit nearest the receptacle.
5. When the terminal is pushed into the re-
ceptacle as far as it will go, the surface
unit will fit into the reflector bowl
Reflector bowls reflect heat back to
the utensils on the surface units. They
also help catch spills. When they are
kept clean, they reflect heat better and
look new longer.
If a reflector bowl gets discolored,
some of the utensils used may not be
flat enough. Or some may be too large
for the surface unit. In either case, some
of the heat that is meant to go into or
around a utensil goes down and heats
the reflector bowl. This extra heat can
discolor it.