Filter
Top Products
Using your miaowave oven
MICROWWE OVEN CONTROLS
There are three parts in the control section:
-The Digital Display/ Clock,
-Command Pads and Signal Lights,
-Number Pads.
What each of these does will be covered
on the following pages. Read them carefully.
When you first plug in the oven, the Display
will show 88:88. If. after you set the Clock
4
ConGal Panel ON /OFF Switch
[page 5), the Display again shows all S’s, it
means your electricity was off for a while
Reset the Clock.
bne note: The Command and Number
[push them. lust touch them. .-I
Pads are not buttons You don t have to
DIGITAL DISPLAY /CLOCK
ma When you are not
using the microwave
oven, this IS an accu-
rate digital clock.
When you are using the microwave oven,
this displays time settings and shows
you
what number pads you touched.
COMMAND PADS AND SIGNAL LIGHTS
Touch Com-
mand Pads to tell
the microwave
oven what to do
and In what order
A few examples:
See page 20 for information on the tone you
hear when touching any pad.
Each Command Pad has its own Signal
Light [except START and CANCEL). The Signal
Lrght comes on when you touch the Com-
mand Pad.
Whrle the oven is running, a Signal Light (or
lights) will be on to show what the oven is
doing
NUMBER PADS