Filter
Top Products
Using The Self-Cleaning
Cycle
In This Section
Page
Page
How the cycle works
. . . . . . . . . . . . . . . . . . . . . . . . 19
Setting the controls . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Before you start . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Special tips
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
22
The Self-Cleaning cycle saves you from the toil and mess that often come with hand-cleaning
the oven interior. Like with the other functions of your oven, you operate the Self-Cleaning
cycle with the easy-to-use electronic control. Please review the instructions in this section to
keep your oven spotless.
How the cycle works
The Self-Cleaning cycle uses very high heat
to burn away soil and grease. During the
cycle, the oven gets much hotter than it does
for normal baking or broiling. This high heat
breaks up the soil or grease and burns it
away.
Your oven is preset for a 3-hour Self-
Cleaning cycle. However, you can adjust the
cycle time to the amount of soil in your oven.
You can set the cycle anywhere between 2
and 4 hours. (See “Setting the controls” on
page 20.)
The graph at the right is representative of
a normal, 3-hour Self-Cleaning cycle. Note
that the heating stops when the 3-hour
setting is up, but it takes longer for the oven
to cool enough to unlock.
Before you start
Before you start the Self-Cleaning cycle,
make sure you:
l Hand-clean the areas shown. They do not
get hot enough during the cleaning cycle
for soil to burn away. Use hot water and
detergent or a soapy steel-wool pad for
cleaning.
NOTE: DO NOT clean, move or bend the
seal. Poor cleaning, baking and roasting
may result.
l Turn off the oven light. Use during the
Self-Cleaning cycle will shorten the life of
the bulb.
START
1
Time 1,’ Hours
3
STOP
Hand-clean door