Whirlpool RF385PXD Range User Manual


 
The electronic oven control
Electronic Timer set and off
display
pads (p.
14)
7 Clock pad
(P. 13)
Manual oven
light pad
(P. 47)
Oven Temperature Electronic Hour Minute Start/ Off/
selector pads MEALTIMEFF pads pads enter cancel
pads
control pads
pad pad
Display/clock
(P. 21) (P. 15) (P. 15)
l
When you first plug In the range, every-
thing on the display will light up for
l-2 sec-
onds, then
a
time of day and “PF will
appear on the temperature display. If, after
you set the clock (page 13) “PF again
appears on the display, your electricity was
off for
a
while. Reset the clock.
l
When you are not using the oven,
the
control
is an accurate
clock.
l
When
you
are
using
the oven or Minute
Timer,
the display will show times, temp-
erture settings, and what command pads
have been pressed.
l
When showing the time of day,
the dis-
play will show the hour and minutes.
l
When you are using the Minute Timer,
the display will show minutes and seconds
in the following sequence:
-For settings from 1-59 minutes,
the
display will count down each second.
-For settings 1 hour or over,
the display
will count down each minute.
l
When you are using Cook Time and/or
CID
Stop Time,
the display
%iMY
STOP
will show hours and
TlME
minutes.
Command pads
The command pads tell the oven what to do
and in what order. A few examples:
- Clock
tells the oven you are
0
going to set the clock.
CLOCK
12
- Off/Cancel
tells the oven to turn off.
Each command pad (except CM/Cancel and
Start/Enter) has its own Indicator Light. The
Indicator Light comes on when you press
the command pad.
Using the control lock
The control lock prevents unwanted use of
the oven by disabling the control panel
command pads.
NOTES:
l
Control lock
is only available when oven
is not in use or control has not been set.
l Set control lock when cleaning the control
panel to prevent oven from accidentally
turning on.
To lock or deactivate the control panel:
Press and hold the Start/Enter pad for 5 sec-
onds. A single tone will sound and
‘Lot” and fi will appear on the
temperature display. When the
control is locked, “START?” will
n the display and three tones will
sound if you press any command pad.
To unlock the control panel:
Press and hold the Start/Enter pad for 5 sec-
onds. A single tone will sound and
“Lot” and fi will disappear from the
temperature display.