Filter
Top Products
PROBLEM POSSIBLE CAUSE
SOLUTION
Burner fails to
The power cord is not plugged
Plug the power cord into a live circuit
light
into a live circuit with proper
with proper voltage. (See Installation
voltage.
Instructions.)
0
A household fuse has blown or
Replace household fuse or reset
a circuit breaker has tripped.
circuit breaker. In case of prolonged
power failure, manually light burners.
(See page 8.)
Burner flames
are uneven
Burner ports are clogged.
Burner ports are clogged.
Clean with a straight pin. (See pages
25 and 26.)
Clean with a straight pin. (See pages
25 and 26.) If this fails, call an autho-
rized Whirlpool service technician for
service.
Burner flames
Air/gas mixture is incorrect.
Contact an authorized Whirlpool
lift off ports,
service technician to check air/gas
are yellow, or
mixture.
are noisy when
turned off
Burner makes
Burner is wet from washing.
Let dry.
popping noise
when on
Control knob(s)
You are not pushing in before Push control knob(s) in before turning
will not turn
turning. to a setting.
Self-Cleaning
The Oven Selector and Oven
Set both the Oven Selector and Oven
cycle will not
Temperature Control are not
Temperature Control to CLEAN.
operate
set to CLEAN.
The range clock does not
Reset clock to show the correct time
show the correct time of day. of day. (See page 11.)
The Lock Lever is not in the
Move Lock Lever all the way to the
CLEAN position - all the way
right.
to the right.
The Start Time Knob does not
Reset the Start Time Knob to show
show the correct time of day or
the correct time of day. Pull knob out
the knob is not all the way out.
all the way.
The Stop Time Knob is not set
See Step 3 in “Setting the controls” on
ahead to the time you want the
page 21 for proper setting instructions.
Self-Cleaning cycle to stop.
continued on next page
29