Filter
Top Products
-8-
Cutting the hole for the WhisperKOOL
unit
Locate the center of the room. Using a
stud finder, locate two adjacent studs in
the walls, and mark them with vertical
lines.
Using a level and a pencil, mark a
horizontal line on the wall between the
two studs, approximately 1.25 inches (or
as close as possible if more than 1.25”)
from the ceiling. Using a ruler or
measuring tape, measure 16 inches down
(22.75” for the 6000 and 8000 models),
and mark another horizontal line parallel
to the first one.
Using a saw, cut along the uppermost
horizontal line until your saw reaches the
stud. Turn the saw around, inserting it
into the cut you have just made, and cut
toward the opposite stud so that you have
a clean horizontal cut between the two
studs. Be careful not to cut into the studs
themselves. Now make the second
horizontal cut from stud to stud on the
line 16 inches below the first cut (22.75"
for the 6000 and 8000 models).
Tools Needed
Mark the horizontal
lines with a level.
Phillips
Screwdriver
Saw
Level Hammer
Cut horizontal
lines from stud to
stud.