3
USER INSTRUCTIONS
HOW TO USE THESE INSTRUCTIONS
The contents of Sections 1, 2 and 3 apply to all the
models in our Electric Range.
The content of Section 4, Remove and Replace Door,
gives different instructions for each model type.
Select the relevant information for your model.
1. IMPORTANT INFORMATION and
HEALTH AND SAFETY
ALL APPLIANCES DESCRIBED IN THESE INSTRUCTIONS
ARE HEAVY. SEEK ASSISTANCE BEFORE UNLOADING
AND LIFTING.
1.1 Read all of the instructions carefully before using the
appliance.
1.2 Remove all packaging and dispose of at an appropriate
recycling facility.
1.3 To remove the protective packaging and fitting kit from
inside a new appliance, choose the instruction
corresponding to your model from Section 4.
1.4 Do not locate this appliance immediately below a fixed
socket outlet.
1.5 The outer casing of this appliance is considered by the
manufacturer to be a working surface which becomes hot
when the fire is switched on. You must use a suitable fire
guard to protect children, the elderly and the infirm.
1.6 Do not use this appliance in the immediate surroundings of
a bath, shower, swimming pool or any other area where
the appliance could come into contact with water or
humidity, e.g. a bathroom.
1.7 WARNING! DO NOT COVER
Do not allow the appliance to be covered or let the air
inlet/outlet become obstructed as the appliance may
overheat. Please note the warning symbol on the appliance
(see above).
1.8 For indoor use only. This appliance is not suitable for use
outside the house.
1.9 Keep the power cord away from hot surfaces and hot
conditions. Do not route the power lead in front of the
appliance.
1.10 This appliance must stand on a clean, level, firm surface.
Do not stand the fire on a carpet. Ensure that furniture,
curtains etc. are positioned no closer than 1m and the fire
stands on a surface that can withstand temperatures of 90°C
for prolonged periods. Do not allow rugs to be placed
within 500mm of the front of the stove.
1.11 When the fire has been installed, the position of the plug
must be accessible.
1.12 Where the electricity supply cable has to pass through a
fire place, stone surround etc. ensure suitable rubber
bushes are fitted at possible wear points.
1.13 If installed in an open fireplace, blank off the chimney to
reduce the risk of a back draught which can cause the
safety cut-out to operate.
1.14 If the electricity supply cable is damaged do not use the
appliance until it has been replaced. For safety reasons the
replacement has to be carried out by Gazco, a Gazco
service agent or a similarly competent electrician.
1.15 Do not use this appliance with any kind of timer,
programmer or thermal control or other device that will
switch the appliance on or off automatically.
1.16 The appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless
they are supervised or have been given instruction
concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that
they do not play with the appliance.
1.17 Do not operate the appliance if it is damaged.
1.18 Repairs of electrical appliances must only be performed by
an electrical engineer. Should the appliance fail to operate,
or in case of any damage, please contact the retailer from
whom the appliance was purchased.
1.19 Never leave the heater unattended while it is in use.
Always switch the product to the OFF position and unplug it
from the electrical outlet when not in use.