Filter
Top Products
1. FITTING STOVES
Most stoves are heavy and do not require anchoring to the
hearth or floor, but in certain circumstances the appliance
can become unstable e.g. when leaning on the stove. If this is
likely, secure the appliance to the hearth or floor with
suitably strong fixings.
FOR MARLBOROUGH, MANHATTAN, STOCKTON &
STOCKTON 5:
1.1 Position the stove ensuring all appropriate clearances are
observed.
1.2 Mark the position of the holes in the fixing brackets
attached to the inside of the rear legs.
1.3 Remove the stove and drill holes using an appropriate
drill.
1.4 Push rawl plugs into the holes and insert the wood
screws until the head is approximately 3mm proud of the
hearth.
1.5 Place the stove in position over the brackets so that the
screw heads locate in the large part of the slot.
1.6 Push the stove back so that the screw heads engage fully
into the narrow part of the slot.
1.7 Tighten the screws if desired.
2. FAULT FINDING
No illumination of the loose fuels or uneven lighting:
2.1 Check the heater is working. If YES, one or more of the
LED boards will need replacing. This must be undertaken
by a suitably qualified person (see Servicing
Requirements).
2.2 If NO, first change the 13amp fuse for one known to
work. If the fire still does not work, check the socket by
plugging in a working appliance. If this too fails to
operate, call in a competent electrician to check the
socket.
Illumination but no heat:
2.3 The safety cut-out has operated to protect against
overheating (see User Instructions, Section 2.6). Ensure
the air inlet and outlet grilles are free of dust or any other
obstruction.
Remote control fails to work:
2.4 Check that the batteries are new and correctly fitted.
Replace if necessary.
2.5 Ensure that the handset is pointed at the window of the
fire.
8
INSTALLATION INSTRUCTIONS
3. HOW TO WIRE A PLUG
If you need to change the plug supplied with this fire,
follow the instructions below. The instructions assume that
the wire has been cut.
WARNING – FAILURE TO CONNECT THE WIRES
CORRECTLY COULD PUT PEOPLE AT RISK FROM
ELECTRIC SHOCK OR FIRE. IF IN DOUBT CONSULT A
QUALIFIED ELECTRICIAN.
UK PLUG - Suitable for use in Cyprus, Malta, Ireland &
Great Britain
Earth wire
Neutral wire
Outer Insulation
Fuse
Cable grip
3
UK Plug Supplied
Type 33
Live wire
Live Wire Brown Terminal L / RED
Neutral Wire Blue Terminal N / BLACK
Earth Wire Green & Yellow
Stripes
Terminal E /
/ GREEN or
GREEN & YELLOW
THIS APPLIANCE MUST BE EARTHED