Filter
Top Products
14
K
To adjust the lower casing
1. Pull out the visor.
2. Loosen the two screws immediately in front
and behind the butterfly bracket screws.
3. Once the screws have been loosened the
lower section of the hood can be moved
backward and forward.
This will allow the alignment of the decor trim
with the wall cabinet above.
Care should be taken when carrying out
the above operation not to loosen the
screws too far, and to ensure that the
casing is supported at all times.
Fitting the Control Panel
The control panel support should be located
on the right hand side in the channel on the
underside of the hood.
Using the screws provided secure the control
box support into the pre-drilled hole.
Clearance Height
The cooker hood can be concealed behind a
decor panel by removing the factory fitted front
strip and fitting a length of lighting pelmet.
K
To remove the front strip
1. Open the visor.
2. Remove the three screws from the reverse
side.
3. Drill the new front strip ensuring the holes
are aligned correctly.
4. Fix the new front strip with the screws
provided.