Zanussi TH 500 Ventilation Hood User Manual


 
8
If after all these checks, the fault persists, con-
tact your local Service Force Centre,
quoting the model and serial number.
Please note that it will be necessary to
provide proof of purchase for any
in-guarantee service calls.
In-guarantee customers should ensure
that the above checks have been made as
the engineer will make a charge if the fault
is not a mechanical or electrical
breakdown.
SERVICE AND SPARE PARTS
If you require an engineer or wish to purchase
spare parts contact your local Service Force
Centre by telephoning:
0990 929929
Your telephone call will be routed to your local
Service Force Centre. For further details please
see the accompanying customer care book.
For general assistance with your appliance or
for information on Zanussi products please
contact our Customer Care Department.
Customer Care Department,
Zanussi
Zanussi House
Hambridge Road
Newbury
Berkshire
RG14 5EP
Tel: 01635 521313
SOMETHING NOT WORKING
If, having followed these instructions carefully, your cooker hood fails to work properly please carry out
the following checks.
Symptom Solution
The cooker hood will not start Check the hood is connected to the electricity
supply.
Check that the fan speed control is set to 1, 2
or 3
The cooker hood is not working effectively The fan speed is set high enough for
the task
The grease filter is clean.
The kitchen is adequately vented to allow the
entry of fresh air.
If set up for recirculation, check that the
charcoal filter is still effective.
If set up for extraction, check that the ducting
and outlets are not blocked.
The cooker hood has switched off during The safety cut-out device has been tripped.
operation Turn off the hob and then wait for the device
to reset.