Filter
Top Products
7
K
To Remove/Replace the Charcoal Filter
1. Open the visor.
2. Remove the metal grease filters.
3. Remove one filter at a time by placing one
hand over the filter and releasing the
spring retaining clip.
4. Allow the filter to hinge back and then
remove.
Worktop lighting
If the fluorescent strip lamp fails to function
first check to ensure that the pins are located
into the holder.
K
Replacing the strip light
1. Remove the lighting diffuser screws,
through the end capping on the right hand
side.
2. Slide the diffuser to the left until the
opposite end is free, then pull the diffuser
down.
3. Remove the fluorescent tube and replace
with one of the same specification.
4. Replace the cover and the retaining
screws.
K
Replacing the strip light starter
1. Open the visor and remove the grease filter
cassette.
2. Unscrew the two fixing screws which
secure the internal cover immediately in
front of the lighting diffuser, on the inside
edge of the casing.
3. Lift the cover from the bottom to remove.
4. Rotate the starter anti-clockwise, and
replace with one of the identical type.