Configurator
CP Input Set
5−70 CM 4000 Installation and Operating Manual
The 15−category factory default set used for CP 3824 panel is as follows:
VTR CG NET VCR CAM
AUX SS REM FILM PTCH
STU TEST SAT FS MISC
The 12−category factory default set used for the CP 3830 panels:
VTR GFX Studio
ENG REM NET
EC POST Xmsn
AUX TEST NUM
Guidelines for using the editor are found on page 5−3.
b. Specify the desired Entry (unit) number. This can be done by double−clicking on the desired “Entry” field and
typing in the number. Press ENTER.
Note: For an input that is heavily used, an entry number of zero can be used to help speed up control
panel operation. For more information, see the note in Step 9 (b) above.
c. Enter the desired Mnemonic.
A CP 320 panel can display four−character mnemonics; the CP 328, CP 3808, CP 3824, and CP 3830 can display
eight−characters.
d. Enter the Input name.
The input name will be a name already entered on the Switcher Input table (page 5−48).
When finished, go to Step 15.
