24 Chapter 1 Troubleshooting control panel messages EN
TRAY X SIZE [SIZE]
Media has been loaded into the specified tray. The most recently
configured size will be displayed with an asterisk next to it.
Action:
1. [– Value +] might be used to view all possible media sizes.
2. Pressing [Select] will select the currently displayed size. Pressing
[Go] will remove the message.
TRAY X TYPE [TYPE]
Media has been loaded into the specified tray. The most recently
configured type will be displayed with an asterisk next to it.
1. [– Value +] might be used to view all possible media types.
2. Pressing [Select] will select the currently displayed type. Pressing
[Go] will remove the message.
TRAY X OPEN
The specified tray is not completely closed.
l Close the specified tray.
WARMING UP
The fuser is warming up. Printing will continue when the fuser reaches
the optimum temperature.
l No action is required.
WASTE TONER FULL
REPLACE DRUM KIT
The waste toner full sensor PS13 detects a waste toner full condition.
A light receiver and light pipe arrangement, along with a window in the
drum assembly, look for a waste fill condition. Verify that sensors and
light pipes are not blocked.
1 Replace the drum kit.
2 Check the sensor, replace it if it’s defective.
www.GovTechMedia.com
