86 Chapter 4 Input/Output (I/O) EN
14 Calibration density settings—On the bottom row of text, there are
four separate blocks of numbers. The first block is for cyan, second
for magenta, third for yellow, and the last is for black. Make sure the
numbers are not near zero (if so, no calibration was done).
Note
For rows one to three, the page count is incremented after every
10 pages. Row four is incremented after every end of page. Rows
one to four are counted through the engine. Rows five and six
are driver requests.
The tray count is incremented based on the tray that is selected
by the firmware, not the tray that is selected by the user.
Media size count is incremented based on the media size that
is selected by the user. Media type count is incremented based
on 1) the media type that is selected by the user when the media
is pulled from tray 1; and 2) the media type configured on the
tray when media is pulled from Tray 2 or Tray 3.
Fuse mode count is incremented twice for duplexed sheets, once
when the front side is fused and once when the back side is
fused.
Row 1: Paper size
www.GovTechMedia.com
