30 Chapter 1 Troubleshooting control panel messages EN
49.ERROR XXXX
CYCLE POWER
(continued)
Note
The printer control panel will display 49 (FFFF) and the display will
be dark if the ribbon cable is not connected.
To verify that the formatter is functioning properly, run the formatter
tests available in the diagnostics mode. If the formatter passes, the
formatter is not defective. DO NOT replace the formatter.
49 ADAC or AFAC
Indicates that the printer is printing a PostScript file using Windows 3.1
or 9x.
l No action required.
49 FF01 to FF05
An NEC firmware ROM error has occurred.
l Replace the firmware.
49 FF02
Unsupported EDO memory has been installed.
l Remove unsupported memory.
49 04CC
Indicates a media timing issue. This occurs when printing multiple
copies of transparencies or heavy or glossy media with either the PCL
or PostScript drivers. Or it could indicate a timing mismatch between
the engine and formatter.
49 04E7
Occurs during decompression of the strip buffers when the end of the
strip marker is missing. This is triggered by one of the following: 1)
Marker is corrupt; 2) Strip buffer size given to HiLite is too small; 3)
Strip buffer size given is too large.
(Continued on next page.)
www.GovTechMedia.com
