Maintenance and Troubleshooting
81ESL E-Series Tape Library User’s Guide
A move command
failed.
■ Check the source and destination. The source should
hold the cartridge to be moved; the destination
should be empty.
■ Make sure the picker is empty and that there are no
obstructions.
■ Also, make sure the library is on-line and the Stop
button is released.
■ Retry the command.
A flash memory error is
reported.
Contact your service provider.
A maximum
temperature exceeded
warning is displayed.
■ Turn off the library and allow it to cool down. Lower
the room temperature, if possible, and increase
ventilation around the library.
■ The air filters may need to be changed.
■ If the operating temperature is too high, the library
automatically shuts down until the temperature drops.
Table 11: Problems during library operation (Continued)
Problem Corrective Action
