A SERVICE OF

logo

Cartridge-door assembly
1. Before proceeding, remove the following components:
Rear-door assembly. See
Rear-door assembly on page 62.
Left cover. See
Left cover on page 66.
Tray 1 (multipurpose tray) cover. See
Tray 1 (multipurpose tray) cover on page 69.
TIP: The cartridge-door assembly can be removed without removing the Tray 1 cover.
However, it is easier to remove and reinstall the door assembly when the Tray 1 cover is not
installed.
2. Remove one spring (callout 1).
Figure 2-37 Remove the cartridge-door assembly (1 of 3)
1
ENWW Removal and replacement procedures 71