Web and MAC Authentication
Configuring the Switch To Access a RADIUS Server
aa-bb-cc-dd-ee-ff
aa:bb:cc:dd:ee:ff
AABBCCDDEEFF
AABBCC-DDEEFF
AA-BB-CC-DD-EE-FF
AA:BB:CC:DD:EE:FF
■ If the device is a switch or other VLAN-capable device, use the base MAC
address assigned to the device, and not the MAC address assigned to the
VLAN through which the device communicates with the authenticator
switch. Note that the switch applies a single MAC address to all VLANs
configured in the switch. Thus, for a given switch, the MAC address is the
same for all VLANs configured on the switch. (Refer to the chapter titled
“Static Virtual LANs (VLANs)” in the Advanced Traffic Management
Guide for your switch.)
Configuring the Switch To Access a
RADIUS Server
RADIUS Server Configuration Commands
radius-server
[host <
ip-address>] below
[key < global-key-string
>] below
radius-server host <
ip-address> key <server-specific key-string> 3-17
This section describes the minimal commands for configuring a RADIUS
server to support Web-Auth and MAC Auth. For information on other RADIUS
command options, refer to chapter 5, “RADIUS Authentication and Account-
ing” .
3-16
