238 AppLock Error Messages
MX6 Reference Guide E-EQ-MX6RG-E-ARC
Message Explanation and/or corrective action Level
has changed the application name or command line.
Registry read failure at reenter user
mode
The registry has to be read when switching into user
mode. This is because the administrator can change the
settings during administration mode. The read of the
registry failed which means the Administration key was
not found or the AppName value was missing or empty.
LOG_ERROR
Registry read failure The registry read failed. The registry information read
when this message is logged is the application
information. It the Administration key cannot be opened
or if the AppName value is missing or empty, this error
is logged. The other application information is not
required. If the AppName value is not available,
AppLock cannot switch into user mode.
LOG_ERROR
Reset system work area failure The system work area is adjusted when in user mode to
cover the taskbar area. The system work area has to be
adjusted to exclude the taskbar area in administration
mode. AppLock was unable to adjust this area.
LOG_ERROR
Shift pressed The Shift key has been pressed and trapped by the
HotKey processing.
LOG_EX
Shift Processing the hotkey and backdoor entry LOG_EX
Show taskbar The taskbar is now being made visible and enabled. LOG_PROCESSING
Switching to admin-backdoor The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of the backdoor key presses were entered by the
administrator.
LOG_PROCESSING
Switching to admin-hotkey press The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of a hotkey press by the administrator.
LOG_PROCESSING
Switching to admin-kbdhook.dll not
found
The keyboard hook load failed, so AppLock switches to
admin mode. If a password is specified, the password
prompt is displayed and remains until a valid password
is entered.
LOG_PROCESSING
Switching to admin-keyboard hook
initialization failure
If the keyboard hook initialization fails, AppLock
switches to admin mode. If a password is specified, the
password prompt is displayed and remains until a valid
password is entered.
LOG_PROCESSING
Switching to admin-registry read
failure
See the explanation of the “Registry read failure” above.
AppLock is switching into Admin mode. If a password
has been configured, the prompt will be displayed and
will not be dismissed until a valid password is entered.
LOG_PROCESSING
Switching to TaskbarScreenMode In administration mode, the taskbar is visible and
enabled.
LOG_EX
Switching to user mode The registry was successfully read and AppLock is
starting the process to switch to user mode.
LOG_PROCESSING
Switching to user-hotkey press The system is currently in admin mode and is now
switching to user mode. The switch occurred because of
a hotkey press by the administrator.
LOG_PROCESSING
Taskbar hook failure AppLock is unable to control the taskbar to prevent the
locked application from re-enabling it.
LOG_ERROR
Taskbar hook OK AppLock successfully installed control of the taskbar. LOG_EX
