15
A forgotten dish can be added at any time before the detergent cup opens.
Open the door a little to stop the washing.
After the spray arms stop working, you can open the door
completely.
Loadthe forgotten dishes.
Close the door, the dishwasher willstart runningagain
after 10 seconds.
4
3
2
1
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
NOTE:
It is dangerous to open the door whenwashing,because the hot water may scaldyou.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8seconds, then stop. Turn off
the appliance using the ON/OFFbutton, shut off the watersupply andopen thedoor of the dishwasher.
Wait for a few minutes before unloading the dishwasher toavoid handling the dishes and utensils while they
arestillhot and more susceptible to breakage. They will also dry better.
Premise:
Otherwise,
the detergent may have already been released, and the appliance
mayhavealreadydrainedthewashwater.Ifthisisthecase,thedetergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Press the button of desired program more than 3 seconds until it's
Indicator is on , after 10 seconds the machine will keep working.
NOTE: If you open the door during washing, the machine
will pause. When you close the door ,
the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher:
a) All program lights off---------------stand by
b) One of the program lights on----------pause
c) One of the program lights blinking----- run
You can modify the washing program, When
the dishwasher just runs for a short time.
Turning on the Appliance
1 Draw out the lower and upper basket, load the dishes and push them back.
It is commended That loading the lower basket first, than the upper one (see
the section entitled "Loading the Dishwasher ").
2 Pour in the detergent (see the section entitled "Salt, Detergent and RinseAid").
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ,
the specification of the socket is 10 A 250 VAC. Make sure that the watersupply is
turned on to full pressure.
4 Close the door , and select the desired programme by pressing the corresponding
button, then the dishwasher will start to work in 3 second.
