.
Plug the interface converter’s Centronics connector
into the socket on the side of the printer. Secure it
with the retaining clips.
.
Connect the interface connector’s 25-pin D-type
connector to one end of the serial converter cable.
.
Plug the other end of the serial converter cable into
one of your computer’s serial ports. The computer’s
serial ports are usually labelled COM 1, COM2 etc.
COMl is normally a g-pin serial port and COM2 is
normally a 25-pin port.
COM2
. . . . . . . . . . . . .
. . . . . . . . . . . .
.
Make sure that the serial-to-parallel converter is
resting on a stable, level surface, so that it will not
be prone to vibration or damage.
Note: Consult your dealer if you are unsure about the type of serial
converter cable that you need.
Page 84
