Filter
Top Products
5
Important Safeguards (Continued)
Figure 1-9 Tape Threading Label
The "Tape Threading Label", shown in Figure 1-9,
is attached to the left side of both the upper and
lower taping heads.
The following two labels are located on the upper
and lower taping heads. Replacement part numbers
for these labels are listed in Section II.
The "Up/Down/Lock" label, shown in Figure 1-8, is
located on the top surface, on each side, of the
upper column assembly. The label reminds the
operator of the direction to turn the height
adjustment crank to raise and lower the upper
ski/taping head and the locking feature.
Figure 1-8 Up/Down/Lock Label
Figure 1-10 Knife Warning Label
The "Warning Sharp Knife" label warns
operators and service personnel of the extremely
sharp knife used to cut the tape at the end of the
box sealing operation. The label, shown in
Figure 1-10, is located on the orange knife guard
between the applying roller assembly and the
buffing roller assembly. Never operate taping
head with knife guard removed.
Before working with the taping heads or loading/
threading tape, refer to Figures 3-1 and 3-2 in
Section II to identify the knife location. Keep hands
out of these areas except as necessary to
service the taping heads or to load/thread tape.