3M 800a3 Food Saver User Manual


 
31
13.11.2 Special Set-Up Procedure (continued)
13.13.3 Drive Belt Assembly Height
The drive belt assemblies can be raised 48mm
[2 inches] to provide better conveying of tall boxes.
This change increases the minimum box height that
can be taped to 190mm [7-1/4 inches].
Disassemble – Figure 13-9
1. It is rst necessary to raise the top taping head.
Utilize the height adjustment crank and move
the upper taping head to the fully raised position.
2. Remove and retain the screw (A), cap washer
(B) and spacer (C) from the front and rear arm
assembly pivots.
3. Lift belt drive assembly (D) up off the arm
assembly pivots.
Reassemble – Figure 13-10
4. Reassemble the spacer (C) onto the front and
rear arm assembly pivots.
5. Install the belt drive assembly (D) onto the pivots
and secure with the cap washers (B) and screws
(A).
Note – Both drive belt assemblies must be
installed at the same operating height.
Figure 13-9 – Drive Belt Assembly, Disassembly
Figure 13-10 – Drive Belt Assembly, Reassembly
2. Slide the head forward and lift straight up to
remove it from the case sealer.
3. Lift the lower taping head, shown in
Figure 13-8C, straight up to remove it from the
case sealer bed.
4. Refer to Manual 2
(Taping Head)
, See
"Adjustments – Changing Tape Leg Length"
for taping head set-up.
To reduce the risk associated with
muscle strain:
Use proper body mechanics when
removing or installing taping heads that
are moderately heavy or may be
considered awkward to lift
WARNING
13-MAINTENANCE AND REPAIRS (continued)
A
A
B
B
C
C
D
D
2011 September
800a3-NA