Filter
Top Products
Installation instructions
Any electrical and/or plumbing work required to install this
appliance should be carried out by a qualified electrician and/or
plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Fitting under a counter (kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close
fitting sink unit or a pre-existing top, providing the dimensions of the
recess correspond to those shown in the picture.
Proceed as follows:
Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull from the front and
slide out the rear slots, lifting the
worktop.
Insert the machine after adjusting
height and levelling with the
adjustable feet. When inserting
the machine, ensure that the
water inlet and drain hoses are
not kinked or squashed.
If the dishwasher is later used as a free-standing appliance, the
original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on
either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable
feet until the machine is perfectly level.
Installation instructions
74
820
570 - 600
600
IN05
152969 94/0de-en 8-04-2003 13:04 Pagina 74