AEG G 330 Dishwasher User Manual


 
Electrical connection
Information concerning the electrical connection is given on the
rating plate on the edge of the dishwasher’s door on the right.
Before plugging the appliance into the wall socket, make sure that:
1. The mains voltage and current rating at the site of installation
match the nominal voltage and current rating given on the rating
plate.
2. The meter, fuses, mains power supply and wall socket can all take
the maximum load required. Make sure that the socket and plug are
compatible without having to use any type of adaptor. If necessary,
have the domestic wiring system socket replaced.
To isolate the dishwasher from mains, remove the mains plug.
Important!
The plug must still be accessible after the appliance has been
installed.
In case that the electrical cable has to be replaced, please contact
your local consumer services department.
The appliance should not be connected to the electrical supply by
means of an extension cable.
Safety standards require the appliance to be earthed.
The manufacture accepts no liability for failure to observe the
above safety precautions.
Installation instructions
78
152969 94/0de-en 8-04-2003 13:04 Pagina 78