Filter
Top Products
Water inlet hose with safety valve
After connecting the double-walled water inlet hose, the safety valve
is next to the tap. Therefore the water inlet hose is only under pressure
while the water is running. If the water inlet hose starts to leak during
this operation, the safety valve cuts off the running water.
Please take care when installing the water inlet hose:
- The distance between the bottom edge of the safety value and the
floor on which the dishwasher is standing must be at least 30 cm:
- The electrical cable for the safety valve is in the double-walled
water inlet hose. Do not immerse the water inlet hose or the safety
valve in water.
- If water inlet hose or the safety valve is damaged, remove the mains
plug immediately.
- A water inlet hose with safety valve must only be replaced by a
specialist or by the consumer services department.
- Place the water inlet hose in such a way that it is never higher than
the bottom edge of the safety valve.
Installation instructions
76
CS19
152969 94/0de-en 8-04-2003 13:04 Pagina 76