Filter
Top Products
INSTALLATION/LEVELLING
The cooker is fitted with mobility rollers, two at the rear and two at the front.
The Four-Two is designed to stand on a flat and level surface, however, any unevenness may
be overcome by adjusting the four levelling feet, one at each corner of the base plate. The
adjusting screws are accessed by removing left and right hand hotplate castings (See section
‘To Remove Hotplate Castings - Servicing Section Page 45). To raise the cooker turn screw
clockwise, to lower turn screw anti-clockwise.
There are rollers on the base of the cooker to allow for positioning.
When the cooker is in the correct position the four levelling feet can be adjusted to level the
cooker. THE FEET MUST BE LOWERED ENOUGH TO PREVENT THE COOKER ROLLING
OUT OF POSITION. (See Fig. 5)
12
DESN 513508Fig. 5
LEVELLING AND MOBILITY WHEELS