Filter
Top Products
27
Using your Range
A dish of water when placed on the rack should be
the same depth all over. (For example, if it is deeper
at the back, then the back of the range should be
raised up or the front lowered). If the range is not
level arrange for your supplier to level it for you.
Oven not coming on when turned on manually
Is the power on? Is the clock illuminated?
If not there may be something wrong with the
power supply. Is the range supply on at the isolator
switch?
Has the time of day been set?
If using the Multi-function oven have you set a
cooking function?
Is the key symbol (
) showing in the display? See
the Clock section of the instructions for more
information on the key lock feature of the clock.
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by
mistake?
Is the key symbol (
) showing in the display? See
the Clock section of the instructions for more
information on the key lock feature of the clock.
If using the Multi-function oven have you set a
cooking function?
Oven temperature getting hotter as the range
gets older
If turning the knob down has not worked or only
worked for a short time then you may need a
new thermostat. This should be fi tted by a service
person.
Broiler not cooking properly
Are you using the pan and grid supplied with the
range? Is the pan being used on the runners, not
the fl oor of the compartment? Is the broiler tray
pushed fully back to stop?
The oven light is not working
The bulb has probably burnt out. You can buy a
replacement bulb (which is not covered under
the warranty) from a good electrical shop. Ask for
a Edison screw fi tting,15w 125-130v lamp, FOR
OVENS. It must be a special bulb, heat resistant to
300°C (570°F).
Turn off the power supply.
Make sure the oven is cool. Open the oven door
and remove the oven racks.
Unscrew the bulb cover by turning counter
clockwise. It may be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover.
Turn on the electricity supply and check that the
bulb now lights.