Filter
Top Products
39
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
The neutral or ground wire of the power cord
must be connected to the neutral terminal
located in the center of the connector block. The
power leads must be connected to the outside
terminals.
Make sure the connections are tight. Now tighten
the stain relief device to clamp the power cord.
Refi t the electrical connection cover
3-Wire Conduit Installation
Disconnect the supplied power cord from
the terminal block and ground post. Keep the
terminal block parts; you will need them. Remove
the strain relief clamp from the power cord and
remove the power cord and strain relief clamp
from the mounting bracket.
The range is shipped with reducer plates to give a
1 1/8’’ diameter opening for conduit connection.
Find the reducer plates in the miscellaneous parts
pack and fi t them to the mounting bracket.
Fit a squeeze connector (not supplied with
the range), to your conduit. Insert the conduit
through the reducer plates on the mounting
bracket. Allow enough slack to easily attach the
wires to the terminal block.
NOTE: Do not install the conduit without a
squeeze connector.
A Ground Strap is supplied in the miscellaneous
parts pack.
ground strap. (grey)
Fit the Ground strap to the ground and center
terminal of the connector block - see the fi gure.
The neutral or ground wire of the power cord must
be connected to the neutral terminal located in
the center of the connector block. The power leads
must be connected to the outside terminals.
NOTE: Make sure the wires are completely inserted
into the terminals and secure connections are
made.
Secure the squeeze connector in place in the
bracket by tightening the squeeze connector
screws.
Seal the Openings
Seal any openings in the wall behind the range
and in the fl oor under the range when hookups are
completed.
When all Connections are Completed
MAKE SURE THE FLOW OF VENTILATION AIR TO THE
RANGE IS UNOBSTRUCTED.