Filter
Top Products
38
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
4-Wire Conduit Installation
Disconnect the supplied power cord from the
terminal block and ground post. Keep the terminal
block parts; you will need them. Remove the strain
relief clamp from the power cord and remove
the power cord and strain relief clamp from the
mounting bracket.
The range is shipped with reducer plates to give a 1
1/8’’ diameter opening for conduit connection. Find
the reducer plates in the miscellaneous parts pack
and fi t them to the mounting bracket.
Fit a squeeze connector (not supplied with the
range), to your conduit. Insert the conduit through
the reducer plates on the mounting bracket. Allow
enough slack to easily attach the wires to the
terminal block.
NOTE: Do not install the conduit without a squeeze
connector.
Fit the
wires to the
ground post
and terminal
block.
NOTE: Make sure the wires are completely inserted
into the terminals and secure connections are made.
Secure the squeeze connector in place in the
bracket by tightening the squeeze connector
screws.
Refi t the electrical connection cover.
Fitting a 3-Wire Power Cord
Disconnect the supplied power cord from the
terminal block and ground post. Keep the terminal
block parts; you will need them. Remove the strain
relief clamp from the power cord and remove
the power cord and strain relief clamp from the
mounting bracket. Discard the strain relief clamp.
NOTE: Do not install the power cord without a
strain relief - use the clamp supplied with the
cord.
Fit the new strain relief device to the mounting
bracket by removing the two clamping screws,
feeding the two halves (ears fi rst) through the hole
in the mounting bracket and loosely refi tting the
screws. Insert the power cord through the strain
relief device but do not tighten the device yet.
A Ground strap is supplied
in the miscellaneous parts
pack.
ground strap. (grey)
Fit the Ground strap to the ground and center
terminal of the connector block - see the fi gure.