Filter
Top Products
INSTALLATION MANUAL • MN-29805 • 13.
MOBILE EQUIPMENT RESTRAINT
INSTALLATION
Any appliance that is not furnished with a
power supply cord but includes a set of casters,
stand with casters, or a stacked configuration
must be installed with a tether. Adequate means
must be provided to limit the movement of this
appliance without depending on or transmitting
stress to the electrical conduit. The following
requirements apply:
1. Casters must be a maximum height of 6" (152mm).
2. Two of the casters must be the locking type.
3. Such appliances must be installed with the use
of a flexible connector secured to the
building structure.
4. Each of the stacked appliances must be
installed with the use of a flexible connector
secured to the building structure. A single wall
anchor may be used.
A mounting connector for a restraining device is
located on the top right back panel of the appliance
chassis or on an oven stand, approximately
18" (457mm) from the floor. A flexible connector is
not supplied by nor is it available from the factory.
WARNING
RISK OF ELECTRIC SHOCK.
Appliance must be secured
to building structure.
Mounting connector for
restraining device