Filter
Top Products
INSTALLATION MANUAL • MN-29805 • 15.
INSTALLATION
WATER CONNECTIONS
WATER SUPPLY & INSTALLATION
WATER REQUIREMENTS
ONE (1) COLD WATER INLET - DRINKING QUALITY
ONE (1) TREATED WATER INLET: 3/4" G
LINE PRESSURE: 30 to 90 psi
2.8 to 6.2 bar
REFER TO PUBLISHED SPECIFIC WATER REQUIREMENTS
WATER DRAIN: 1-1/2" CONNECTION WITH A 2” MINIMUM AIR
GAP INSTALLED AS CLOSE TO THE OVEN AS POSSIBLE. MATERIAL MUST
WITHSTAND TEMPERATURES UP TO 200°F
Flush the water line at the installation site.
Install water intake filters (provided) [see Figure 1]
before connecting the oven to the water supply.
Backflow Prevention — The equipment must be
installed with adequate backflow protection to
comply with applicable federal, state, and local
codes.
PIPE SEALING TAPE (
TEFLON®) MUST BE USED
AT ALL CONNECTION POINTS. The use of a pipe
sealing compound is not recommended.
HAND SPRAYER VALVE
REQUIRES ADDITIONAL
WATER SUPPLY
3/4" G
1-1/2" DRAIN
WATER INLET
CLEAN-OUT
TANK
Incoming cold water
connection to filter or
treatment system
Treated cold water
to backflow preventer
to treated connection
on oven
Water Filter
Install water
intake filter
Figure 1
ONE SUGGESTED
METHOD OF INSTALLATION
NOTE:
UNIONS OR FLEXIBLE LINES
SHOULD BE USED TO ALLOW FOR
OVEN MOVEMENT WHEN BEING
SERVICED OR CLEANING
IS NEEDED.
REFER TO FIGURE 1 ABOVE FOR
PROPER INTAKE LOCATIONS.
CombiGuard™
FI-23014 shown
Alto-Shaam now offers an improved water filtration
system for Combitherm
®
. The CombiGuard™ triple-guard water filtration
system filters dirt, sediment, and other debris as small as 1/2 micron.
This system also significantly reduces chlorine content to protect against
corrosive chorine compounds. CombiGuard improves equipment efficiency,
reduces service requirements and extends the life of the Combi oven. After
installation, confirm that water quality standards specified in this manual
are being met. Filtration systems include one filter cartridge. Additional
cartridges can be purchased separately. Refer to page 7 for additional
ordering information.
The CombiGuard™ BWS Blended Water System utilizes reverse osmosis to
remove more than 97% of the total dissolved solids from water which can be
precisely blended with filtered and treated water.