Amana ARG7302 Range User Manual


 
9
Converting Type 2 Pressure Regulator for Use with
LP/Propane
1. Remove pressure regulator cap with a
wrench.
2. Reverse pressure regulator cap.
Cap must show “LP”.
3. Place pressure regulator cap on pressure regulator
and tighten.
Cap
LP
Type 2 Pressure Regulator
Converting Surface Burners for Use with LP\Propane
1. Remove 4 burner control knobs from range.
Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See
Pivot Point
in figure.
Gas valve and orifice hood are visible after burner
control panel is removed.
A
B
C
D
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
Burner Control Panel
4. While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
Use ½ inch open end or 90° offset open end
wrench.
Do not over tighten orifice hoods. If orifice hoods are
over tightened, gas supply can be cutoff or orifice
hoods can strip.
5. Open air shutter fully.
A
B
Open Fully
A—Orifice Hood
B—Air Shutter
Converting Surface Burners for Use with LP\Propane
6. Reassemble burner control panel after adjusting air
shutter.
See
Adjusting Surface Burner Flame
section.