Filter
Top Products
15
Other Features
Adjusting Factory
Set Baking
Temperature
Oven temperature is set at factory. When first using oven, follow recipe times and
temperatures. If you think oven is too hot or too cool, temperature can be adjusted. Before
adjusting oven baking temperature, test a recipe by using a temperature set higher or
lower than the recommended temperature. The baking results should help you to decide
how much adjustment is needed.
1. Turn oven temperature knob to
OFF
.
2. Press and hold
HRS
+ and
HRS
- pad for approximately 5 seconds.
• Display shows current offset temperature.
3. Immediately, press either
HRS
+ or
HRS
- pad.
•
HRS
+ increases oven temperature by 5°F.
•
HRS
- decreases oven temperature by 5°F.
• Oven temperature can be changed up to 35°F. When temperature is adjusted cooler
“-” shows in display followed by offset temperature.
• After a few seconds control saves setting and returns to previous display.
12-hour automatic
cancel
As a safety feature, oven control automatically shuts off oven after 12 hours of operation.
This feature can be turned on or off.
To allow the oven to operate for more than 12 hours, confirm temperature knob is in
OFF
position. Then, press and hold the
MINS
+ and - pads for approximately
4 seconds. Display will change from time-of-day and show “OFF”.
To set oven to shut off after 12 hours, confirm temperature knob is in the
OFF
position.
Then, press and hold the
MINS
+ and - pads for approximately 4 seconds. Display will
change from time-of-day and show “ON”.
Service codes and
tones
Electronic oven control is equipped with a self diagnostic system. Self diagnostic system
alerts you if there is a error or problem in the control. When electronic range control signals
a problem, follow steps listed below.
1. Record “F-code” shown.
• FFF—control malfunction.
• F2—high oven temperature.
• F3—open temperature sensor or circuit malfunction.
• F4—shorted temperature sensor or circuit malfunction.
2. Disconnect and reconnect electrical supply.
• Disconnecting electrical supply may eliminate “F-code”. If failure continues, contact
an authorized servicer.