Filter
Top Products
9
Converting 3-Wire to 4-Wire Power Cord
1. Remove rear wire cover.
2. Remove bottom strain relief screw and retain for
further use.
3. Remove screw/hex nuts from terminal block and
retain for further use.
4. Remove all 3-wire or cable leads from the terminal
block and proceed to remove the power cord from the
range by pulling in a downward motion so the cord is
removed from strain relief.
5. To install the 4-wire cord, please follow step 3
through step 9 of
Installing 4-Wire Power Cord
section.
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1. Measure 3
1
/2 inches from back wall on right and left
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
line drawn 3
1
/2 inches from back wall and side of
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
or
3 1/2"
Anti-tip Bracket Installation
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
3
/32-inch drill bit.
• If drilling into concrete, use a
3
/16-inch masonry drill
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. Slide range into position, remove range storage
drawer or lower panel and confirm anti-tip bracket is
engaged with range leveling leg.
Level Range
CAUTION
!
To avoid damaging oven door, do not lift or move range
by oven door handle. Glass can break.
Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
• Place a level on top oven rack or on range top when
leveling.
• Leveling legs must extended ¼ inch to engage anti-tip
bracket.
Removal and Replacement of Range
1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
4. Remove anti-tip bracket.
5. Install anti-tip bracket into new location using
instructions provided with bracket or see
Anti-tip
Bracket Installation
section in this manual.
6. To reinstall range, follow instructions in
Installation
section of this manual.