Filter
Top Products
18
WARNI NG
!
To avoid risk of personal injury,
do not touch range top, door,
oven vents, or area around
vents, during self-cleaning.
These areas can become hot
enough to cause burns.
Self-cleaning
Self-clean feature uses high oven temperature to clean oven interior.
For the oven to operate through a complete self-clean cycle, the
self-clean must be set when the oven is cool.
1. Prepare oven for self-cleaning (see below left).
2. Close door.
3. Press CLEAN pad.
SET CLEAN TIME flashes in display.
The default self-clean cycle length of 3 hours displays.
Adjust clean cycle length by using digit pads (1 through 0).
Clean cycle can be set from two to four hours in one minute
increments.
4. Press START pad.
CLEAN, TIME, LOCK, ON and both bake
and broil element graphics display.
Surface burners should not be used until
completion of self-clean cycle.
At the end of self-clean cycle, ON no longer
displays.
LOCK will remain on until oven reaches a cooler temperature.
LOCK will flash while door is unlocking, and then shut off when
door has unlocked. Oven cavity will be hot to the touch.
DO NOT attempt to open door prior to LOCK shutting off.
Interrupting the self-clean cycle
To stop a self-clean cycle that has already started follow these steps.
If the interruption occurs mid cycle, the oven will remain locked, even
though the cycle has stopped, until the oven cavity has cooled to a
lower temperature.
1. Press OVEN CANCEL.
2. When oven has cooled to a lower temperature, LOCK light
turns off. Door can be opened. DO NOT force door.
This can cause damage to the latch.
Using the Oven Control (cont'd)
CAUTION
!
To avoid fire or smoke damage,
remove any flammable
materials from storage drawer.
Items like plastic containers and
paper manuals can melt or burn.
clean excess spills before
starting a self-clean cycle.
Do I need to prepare?
To get the best results from the
self-clean cycle, follow these steps:
• Clean excess spills from oven
interior and oven burner well.
• Remove birds or animals
susceptible to smoke or other
fumes from the room or
adjoining room.
• Open window if possible.
• Make sure oven light cover is
properly in place. Do not use
cleaning cycle if it is not.
• Remove oven racks, pans and all
cooking utensils from oven.
• Remove items from range top,
storage drawer, and backguard.
These areas can become hot during
self-cleaning cycle.
• The range vents from the center
bottom of the backguard. Make
sure this area is unobstructed by
removing all items from backguard
and range top.
Operating surface burners during a self-clean cycle
Your range is equipped with a safety feature to prevent it from overheating
during a self-clean cycle. A special temperature sensor shuts off the self-
clean cycle if the range becomes too hot. Depending on the range and the
length of cooking time on the surface burners, the sensor may or may not
shut off the self-clean cycle. To prevent any self-clean cycle disruption, it is
best not to use the range surface burners during a self-clean cycle.