Filter
Top Products
11
Electronic Oven Control
TIMING
TIME / TEMP SET
TIMER
ON/OFF
CLOCK
STOP
TIME
COOK
TIME
OVEN
CANCEL
LIGHTCLEAN
BROIL
BAKE CONV.
DELAY BAKE CLN STOP TIMER
BROIL CONV
DELAY BAKE
CLEAN LOCKED
Electronic Oven Control Pads
TIMER ON/OFF
• Use to time any kitchen function or cancel timer.
• Does not control bake, broil, or clean function.
CLOCK
• Use to set time of day.
STOP TIME
• Use to set delayed bake or delayed self-clean.
COOK TIME
• Use to set delayed or timed bake.
CLEAN
• Use to select self-clean cycle.
BROIL
• Use to select broil.
BAKE
• Use to select bake.
CONV
.
• Use to select convection.
or —Used to set temperature or time.
OVEN CANCEL
• Cancels any cooking or cleaning function except
timer.
LIGHT
•
Used to turn on and off light inside oven.
Special Oven Control Functions
Timer Signal—When time elapses timer beeps 3 times
then once every 10 seconds.
Preheat Signal—After setting oven to bake and selecting
a temperature, oven preheats. When oven reaches set
temperature, oven signal sounds 3 times.
End of Cycle Signal—When a timed cooking cycle is
complete, three long signals sound. After first 3 signals,
1 signal sounds approximately every 10 seconds for 5
minutes or until OVEN CANCEL pad is pressed.
Child Lock Out — This is a safety feature that can be
used to prevent children from accidently programming the
oven. It disables the electronic oven control. Touch and
hold Bake and Cook Time for 10 seconds. “OFF” will
display where the temperature normally appears.
To reactivate the control, touch and hold Bake and Cook
Time for 10 seconds. Child lockout features must be reset
after a power failure.
12 Hour Automatic Cancel—This is a safety feature that
prevents oven from continuing to operate if it has been left
on for over 12 hours. If a cooking function continues longer
than 12 hours without any options on oven control being
touched, this feature turns oven off. Any time an option is
touched, 12 hour automatic cancel is reset.
Increasing or Pad Speed—When setting time and
temperature, hold pad to accelerate the rate at which the
numbers increase or decrease.
Self-diagnostic System—Electronic range control has a
self-diagnostic system. Self-diagnostic system sounds a
series of short, rapid beeps and shows a “F-code” in
display when there is a problem. See “Service Tones and
Codes” section.