Filter
Top Products
9
Operation
Surface Elements
• Do not use a pan that overhangs burner by more
than 1 inch.
1. Push in and turn surface element control to desired
setting.
• Ranges with coil elements have two indicator lights,
one for elements on right side and one for elements
on left side of range. When either front or rear
element is on, corresponding indicator light glows.
• Smoothtop ranges have four hot indicator lights,
one located above each knob. Hot indicator lights
will glow red when the corresponding element is
turned on. Light will remain on until surface element
has cooled to a safe temperature. Element cycles
on and off to maintain desired heat setting.
2. When finished cooking, turn control to “OFF” position.
OFF
LO
HI
MED
Settings
LO
Use to prepare food at less than boiling temperatures or
to simmer.
MED
Use to maintain boiling of larger amounts of food, low
temperature frying and to maintain correct pressure in a
pressure cooker.
HI
Use to bring food to boiling temperatures. When food is
boiling temperature setting should be reduced to MED
through HI.
Level Range
Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
• Place a level on top oven rack or on top of range
when leveling.
• Leveling legs must be extended a minimum of
¼ inch (6mm) to engage anti-tip bracket.
1. Extend leveling legs so when range is moved into position
range top clears counter top.
2. Slide range to where it will be installed.
• Position range so that rear leveling legs do not
engage anti-tip bracket.
3. Turn leveling legs to level range.
• Turn legs clockwise to decrease range height or
counter clockwise to increase range height.
• Adjust rear leveling leg that engages anti-tip bracket
first. Leveling leg can not be adjusted while in
bracket. After adjusting leg that engages anti-tip
bracket, slide range forward until leg engages
bracket, and adjust other legs.
4. Replace storage drawer.
Removal and Replacement of Range
1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
3. Remove anti-tip bracket.
4. Install anti-tip bracket into new location using
instructions provided with bracket or see “Anti-tip
Bracket Installation” section in this manual.
5. To reinstall range, follow instructions in “Installation”
section of this manual.
CAUTION
To avoid damaging oven door, do not lift or move range
by oven door handle. Glass can break.
WARNING
To avoid risk of serious personal injury, property damage,
or fire, do not leave surface elements unattended while in
operation. Grease and spillovers can ignite causing a fire.
Surface Element Control Knob